Search results for 'electric tankless water heater'

One required for each tankless water heater installed in a manifold. Connects a single tankless water heater to the MIC-6.

The Recessed Box provides a clean finish to an outdoor installation -- a great look for residential and commercial installs.

If purchased with a tankless water heater, then the Recessed Box is discounted to $275!

One required for each tankless water heater installed in a manifold. Connects a single tankless water heater to the MIC-6.

Makes installing your tankless water heater easy! Designed to save time and ensure that installation is completed in a professional manner.

WTIV + PRV for $59, with purchase of any gas tankless water heater. A $77.50 value.

Converts your tankless water heater for commercial use up to 185F with simple addition of hi temp computer chip.

These kits are for high volume commercial use, 140F -- 185F.

Limited Warranty

• 5 years on heat exchanger and parts

• 1 year on labor

 

BE SURE TO NOTE YOUR MODEL#  BEFORE ORDERING CHIP

Use WM-6.0 and Wilo Pump as the heat source for your domestic recirculation system. Only circulate through the mini tank, extending the life of your tankless water heater by not subjecting it to constant recirculation. Use WM-6.0 as a buffer tank to eliminate cold water sandwich, which is possible with frequent on/off operation of the tankless. Cold water, sandwiched between hot water, is diluted into the mini tank and eliminated. Seal-less magnetic drive circulator with union or solder connection. Jet Connect fitting pack included. Compact, magnetic drive design. Six inch power cord included. Optional timer available. Domestic hot water re-circulation systems. NSF approved for drinking water applications. Recirulate using WaiWela WM-6.0 Mini Tank.

One required for each tankless water heater installed in a manifold. Connects a single tankless water heater to the MIC-6.

Run your Paloma Tankless SOLO, or combine two units together for a Tankless DUO with 2X the performance.

The Water Valve Rebuild Kit contains all the parts needed to replace the water control valve assembly.

The water control valve assembly may need to be replaced when:

• Main burner will not turn on
• Main burner is on low flame
• Water is not hot enough, or as hot as usual

IN THE KIT

• Diaphragm
• “O” Ring
• Spindle
• Washers
• Retaining Clip
• Instructions