Accessories
-
Paloma PH25 Series Pipe Cover - Direct Vent Indoor
Gives a clean finishPipe Cover for Direct Vent Indoor Tankless Water Heaters$89.00 -
3" PHH-DV Horizontal Termination
3 Inch Horizontal Termination for PHH-DV Series3 Inch Horizontal Termination for PHH-DV Series$30.00 -
MIC-Q-1 Manifold Control Cable (1-ft)
1 foot control cable.One required for each tankless water heater installed in a manifold. Connects a single tankless water heater to the MIC-6.$15.00 -
DUOnex™ Cable
Connects two tankless water heaters for 2x the performanceRun your Paloma Tankless SOLO, or combine two units together for a Tankless DUO with 2X the performance.$25.00 -
Commercial Conversion Kit
Converts your tankless water heater for commercial useConverts your tankless water heater for commercial use up to 185F with simple addition of hi temp computer chip.
These kits are for high volume commercial use, 140F -- 185F.
Limited Warranty
- 5 years on heat exchanger and parts
- 1 year on labor
BE SURE TO NOTE YOUR MODEL# BEFORE ORDERING CHIP
$30.00 -
Paloma PHH-32R Series Pipe Cover
Gives a clean finishPipe Cover for PHH Tankless Water Heaters$89.00 -
Paloma Vertical Condensate Collector - for PHH-32RDV
Vertical Condensate Collector for PHH-32RDVFor use on the PHH-32RDV. Install on the fresh air intake to dissipate condensate. For vertical venting.$18.00 -
Paloma Bath Remote Control 2
Bath Remote Control is intended to be installed in bathroom area. Temperature adjusting range 100F-120F.Bath Remote Control is intended to be installed in bathroom area. Temperature adjusting range 100F-120F.Regular Price: $150.00
Special Price: $99.00
-
Paloma PH25 Series Pipe Cover - Outdoor
Gives a clean finishPipe Cover for Outdoor Tankless Water Heaters$89.00 -
Water Valve Rebuild Kit
The Water Valve Rebuild Kit contains all the parts needed to replace the water control valve assembly.
For Paloma PH5, PH6, PH12/PH16/PH24 Tankless Water Heaters
The Water Valve Rebuild Kit contains all the parts needed to replace the water control valve assembly.
The water control valve assembly may need to be replaced when:
- Main burner will not turn on
- Main burner is on low flame
- Water is not hot enough, or as hot as usual
IN THE KIT
- Diaphragm
- “O” Ring
- Spindle
- Washers
- Retaining Clip
- Instructions
$45.00